The Physical layer works with which of the following: A.) Segments B.) Dat

The Physical layer works with which of the following:

A.) Segments

B.) Datagrams

C.) Packets

D.) Bits

E.) Frames

Question Posted / guest

3 Answers
8536 Views
BITS, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

The Physical layer works with which of the following: A.) Segments B.) Datagrams C.) Packet..

Answer / guest

The correct answer(s): D

Physical - bits

Datalink - frames

Network - packets

Is This Answer Correct ?

24 Yes

1 No

The Physical layer works with which of the following: A.) Segments B.) Datagrams C.) Packet..

Answer / nilesh

bits

Is This Answer Correct ?

7 Yes

0 No

The Physical layer works with which of the following: A.) Segments B.) Datagrams C.) Packet..

Answer / abhishek

the correct answer d.bits

Is This Answer Correct ?

7 Yes

2 No

Post New Answer

More CCNA Interview Questions

What is a disadvantage of using a connection oriented protocal such as TCP? A. Packet acknowledgement may add overhead B. packets are not tagged with sequence numbers C. Loss or duplication of data packets is more likely to occur D. The application layer must assume responsibility for correct searchers of the data packets

1 Answers

What is the Difference between Switch and Bridge?

9 Answers

Which of the following is an example of the Network Layer? A.) Token Ring B.) RARP C.) LLC D.) DDP E.) TCP

1 Answers

Which OSI Reference Layer controls application to application communication? A.) Datalink B.) Network C.) Transport D.) Session E.) Physical

2 Answers

Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port

1 Answers

What information is provided by the local management interface (LMI)? A.) LMI encapsulation type B.) The current DLCI values C.) The status of virtual circuits D.) The global or local significance of the DLCI values

1 Answers

Which device works at the Network Layer of the OSI model? Router Switch Bridge Hub

5 Answers CET, IBM,

Which two commands show your access lists? (Choose two) A. show filters B. show access-lists C. show ip access-lists D. show running-config

2 Answers

Write an access list line which will deny node 20.0.2.1 to anywhere on your network using DNS via UDP. Don't worry about the other access list lines.

2 Answers

Which commands should you use to enable IGRP routing? A. router igrp 100 Network 192.168.1.0 Network 10.0.0.0 B. router igrp 100 Network 192.168.2.0 Network 10.0.0.0 C. router igrp 100 Network 192.168.1.0 192 168.1.1 Network 10.2.0.0 10.2.1.1 D. router igrp 100 Network 192.168.1.0 255.255.255.0 Network 10.2.0.0 255.255.255.0

3 Answers

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers

what's the difference between Symmetric and Asymmetric cryptosystem?

0 Answers CCIE,

For more CCNA Interview Questions Click Here