Which type of switching reads in the entire frame before
forwarding it?
A.) Tabling
B.) Store-and-Forward
C.) Inverse ARP
D.) Fast Forward
E.) Cut-Through
F.) Routing
Answer / guest
Answer: B
Store-and-Forward is slower, but it checks the frame for
errors before
forwarding. This can actually help to improve overall network
performance on noisy lines.
Is This Answer Correct ? | 0 Yes | 0 No |
What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards
Hi all, suppose more than two network administrators are configure same router with different configuration through telnet at the same time.. then whose(admin's) configuration will use router for routing ?
Identify the access-list range for an extended IP access-list? A.) 800 - 899 B.) 1 - 99 C.) 1000 - 1099 D.) 100 - 199
Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP
What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM
what is ping utility and how to work.
What is an advantage of UDP? Low Overhead High Overhead Reliable Not reliable
255.255.255.128/what is the n/w id ,broadcast id and the number of valid host(according to disco rules)
which defined peer ip address an local subnet belong to crete? (Choose two)
Which of the following is True regarding passwords on a Cisco router? A. All passwords can be encrypted B. All passwords can be entered using the set-up dialogue C. A password can be set before a user can enter the privileged mode D. A password can be set for individual lines E. TACACS or Radius password authentication can be used.
How many maximum paths you can give on latest ios in rip?
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number