Which of the following provide correct information about a
protocol at the transport layer of the OSI model?
A.) UDP - Provides Connectionless datagrams service
B.) TCP - Provides Connection Oriented Services
C.) SMTP - Provides Mail Exchange
D.) IP - Route determination
E.) TCP - Provides Flow Control and Error Checking
F.) FTP - Transfers of Files
- 2 Answers
- 4307 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A B E
Only TCP and UDP work at the Transport layer of the above
choices. IP is
a Network layer protocol. SMTP and FTP are application layer
protocols.
| Is This Answer Correct ? | 4 Yes | 0 No |
What is difference between flsm and vlsm?
What is difference between static and dynamic routing?
Which three commands are used to configure information into RAM on a router? (Choose three) A. configure memory B. configure terminal C. configure overwrite D. copy tftp startup-config E. copy running-config startup-config F. copy startup-config running-config
What is the mesh network?
Which router command allows you to determine if an IP access list is enabled on a particular interface? A. Router# show ip interface B. Router> show access-list C. Router# show ip access-list D. Router> show interface ip access-list E. Route 1 P.O. box 198
When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A
Explain what is 5-4-3 rule?
What is the size of IP address?
Which statement is true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not a the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth
What command displays detail information about the OSPF interfaces, including the authentication method?
Identify the length of an IPX address and it's components? A.) 80 bits, 48 bits network and 32 bits node B.) 32 bits, 16 bits network and 16 bits node C.) None of the above D.) 80 bits, 32 bits network and 48 bits node
What are the protocols that are used by every layer of ip/tcp model?
CCNA 
