Identify 3 characteristics of ISDN?
A.) Transports voice and data
B.) Transports voice only
C.) Support both BRI and PRI
D.) Runs over existing phone lines
E.) Same as X.25
Answer / guest
Answer: A C D
ISDN supports voice, data, and video. It runs over existing
phone lines
and supports 128K (BRI) and T1 (PRI).
Is This Answer Correct ? | 5 Yes | 0 No |
What is SIA (Stuck in Active) in EIGRP?
7 Answers Cap Gemini, Hathway, Reliance Jio,
What are the OSPF router rules????
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop
In how many ways can data be transferred in ccna?
What are the 2 functions of the Data Link Mac layer? A.) Handles access to shared media B.) Manages protocol access to the physical network medium C.) Provides SAPs for higher level protocols D.) Allows multiple devices to uniquely identify one another on the data link layer
Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup
Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102
What is the passive topology in ccna?
What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi