What is the purpose of the DLCI?
A.) Identifies the remote routers
B.) Contained with a 802.2 frame for routing purposes
C.) Used with PPP during authentication
D.) Identifies the PVC in a Frame Relay network
Answer / guest
Answer: D
DLCI stands for Data Link Connection Identifier. It
identifies the local
PVC.
Is This Answer Correct ? | 19 Yes | 3 No |
what is stp.
Which command allows a user to see previous commands? A.) show command B.) CTRL-P C.) show history D.) CTRL-U E.) Up Arrow F.) SHIFT-CTRL-6
What are the possible ways of data exchange in ccna?
Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-
Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes
HIGH MY ALL FRIENDS. CURRENTLY I AM WORKING DESKTOP SUPPORT ENGINEER IN mahindra & mahindra lTD.I AM CERTIFIED IN CCNA SINCE 28 DEC 2009.BUT I HAVE NOT RECEIVED CCNA CERTIFICATE. PLEASE HELP ME ..HOW RECEIVE THE CCNA CERTIFICATE.IF ANY INFORMATION IS AVAILABLE PLS SEND INFORMATION TO MY GMAIL ID.MY ID---- ngawde.cisco@gmail.com ngawde@yahoo.com
. Which command sequence will allow only traffic from network 185.64.0.0 to enter interface s0? A. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-list 25 out B. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-group 25 out C. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-list 25 in D. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-group 25 in
What does the IPX maximum path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)
Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -
What is difference between switch & hub?
switch kitne volt per work karta hai. what is frame realy. what is isdn and pri and bri.
Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version