Answer / guest

Answer: B

SAP is an Novell protocol to advertise services.

How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Rotuer(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run

1 Answers  

---

Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols

3 Answers  

---

Does a bridge divide a network into smaller segments?

0 Answers  

---

Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?

2 Answers  

---

Explain what is route poisoning?

0 Answers  

---

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

1 Answers   Cisco, HCL,

---

What is Standard ACLs?

5 Answers   HP,

---

If you are in IOS user mode, which command do you use to enter the privileged mode? A. Set B. Enable C. Configure D. Privileges

2 Answers  

---

ok this is practical senario question how can we comunicate two diffrent network host by i single 1603 sires of cisco router rember that the cisco series of that router have singe 100mbps ethernet now think think write all command answer is so simple i wiil; give the answer after 20 visit til then wait

2 Answers  

---

Interface 0/0 what does it mean?

0 Answers  

---

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

1 Answers  

---

ip dhcp excluded-address 192.168.0.1 192.168.0.19 what is the use of that command can any one explain it

9 Answers  

---