Identify 3 LAN technologies?
A.) FDDI
B.) HDLC
C.) HSSI
D.) X.25
E.) 802.3
F.) 802.5
- 1 Answers
- 6534 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A E F
The question is asking for 3 LAN technologies, HDLC, HSSI
and X.25 are
all WAN technologies.
| Is This Answer Correct ? | 6 Yes | 0 No |
Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route
Given an IP host address of 172.16.2.160 and a shored mask of 255.255.255.192 to which shored does the host belong? A. 172.16.2.32 B. 172.16.2.64 C. 172.16.2.96 D. 172.16.2.128 E. 172.16.2.192
which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance
What is the last step in data encapsulation? A.) User information is converted into data. B.) Segments are converted into datagrams and packets. C.) Frames are put into bits. D.) Data is converted into segments. E.) Packets are put into logical frame.
Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol
On which interface we always apply access-list?
Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction
Identify the default IPX serial encapsulation? A.) Novell-Ether B.) SDLC C.) SNAP D.) HDLC
Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router
Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
What is mac address size of ipv6?
What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place
CCNA 
