When using RIP, routing updates are broadcast every ____
seconds.
A. 30
B. 10
C. 60
D. 90
Answers were Sorted based on User's Feedback
Answer / mohammad wasif
when we using RIPv1, there is routing updates are broadcast every 30 seconds.
so, answer (A) is correct
Is This Answer Correct ? | 6 Yes | 0 No |
Answer / guest
Answer:: A
Novell's RIP updates routing tables every 60
seconds, Apple's RTMP is every 10 seconds, routers ARP every
60 seconds, DECnet hosts and IGRP signal every 15 seconds,
and Banyan VINES signals every 90 seconds.
Is This Answer Correct ? | 6 Yes | 3 No |
Rip routing updates every 30seconds.
Is This Answer Correct ? | 2 Yes | 0 No |
Does a bridge divide a network into smaller sections?
Of the following characteristics, which apply to UDP? Connection-oriented Connectionless Error checking Low overhead Best-effort delivery
What is the simplest way to remotely configure a router?
Differentiate User Mode from Privileged Mode?
Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx
Want to be a Cisco certified person through authorized training and certification center ?
What is bia?
Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured
Identify the named IP access-list number range? A.) 600 - 699 B.) 1 - 99 C.) 900 - 999 D.) 200 - 299 E.) none of the above
1350 Value in which type of access-list?
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full
Explain what is 5-4-3 rule?