What does the following series of commands accomplish?
router igrp 71
network 10.0.0.0
router igrp 109
network 172.68.7.0
A. It isolates networks 10.0.0.0 and 172.68.7.0.
B. It loads igrp for networks 109 and 71.
C. It disables RIP.
D. It disables all routing protocols.
Answer / guest
Answer: A
It isolates network 10.0.0.0 and 172.68.7.0 and
associates autonomous systems 109 and 71 with IGRP. IGRP
does not disable RIP, both can be used at the same time.
Is This Answer Correct ? | 3 Yes | 0 No |
Which configuration task must you complete if a remote Frame Relay router does NOT support Inverse APP? A.configure static maps B.define an IP address locally C.disable DHCP on the Frame Relay router D.configure a static route to the remote network
You need to come up with a TCP/IP addressing scheme for your company. How many network IDs must you allow for when you define the subnet mask for the network? A.) One for each WAN link B.) One for each router interface C.) One for each NIC installed in each client D.) One for each subnet with hosts E.) One for each host ID
Can you explain PPP protocol?
What’s the simplest way to remotely configure a router?
Suppose a USER is saying he is not able to access the internet or page loading is slow what trobleshooting steps you will take to get it fixed
What is the Cisco name for the encapsulation type used on a serial interface? A. HDLC B. SDLC C. SAP D. SNAP
What is a back off on an 802.3 networks? A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. It is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged
Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'
What is the function of Layer 2 Switch?
Tell me which cable we connect in db-9?
Identify the 3 characteristics of IPX RIP? A.) Distance vector B.) Does not support multiple paths C.) 60 second updates D.) Default encapsulation is SAP E.) Uses ticks and hop count as a metric
Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation