Interested to Buy Any Domain ? << Click Here >> for more details...
As a system administrator, you want to debug igrp but are
worried that the "debug IP igrp transaction" command will
flood the console. What is the command that you should
use?
A. debug IP igrp event
B. debug IP igrp-events
C. debug IP igrp summary
D. debug IP igrp events
- 1 Answers
- 6557 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: D
The "debug IP igrp events" is used to only
display a summary of IGRP routing information. You can
append an IP address onto either command to see only the
IGRP updates from a neighbor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Explain isakmp ?
Which protocol works only on cisco routers?
Which of the following is a routing protocols? TCP RIP SMTP UDP
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM
Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.
How many voltage that passes through the ISDN?
4 Answers CTS, Swirl Infosystems,
What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN
Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation
What is the command use to add a banner to a cisco router configuration?
what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain
Write the procedure for Router for configuring DHCP?
CCNA 
