MY generator water cooler inlet line height - 11 mtr
inlet water line height - 7 mtr
water come into the line from overhead tank, O/H tank
height - 20 mtr
the first tapping in the inlet line is 2" line which down
to 4 mtr level plateform., second tapping in inlet water
line goes to a pump 6" line installed at 4 mtr level
plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the
outlet of pump of 6" water line connected to a header of 6
mtr long of 6" line, on this header the six tapping are
connected, 4 nos. 3" line goes to 11 mtr height water
cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2"
and 4" pipe line connected to a cooler at 4 mtrlevel
my question is, at 11 mtr height level the quantity of
water and flow is not sufficient for my cooler, the temp.
of cooler is rises much more. you are requested to suggest
the modification of pipe line/ pump for take more water
flow and pressure (desired pressure is 1 kg/cm2)
Hello i am a chemical engineer presently looking for a job i
am applying many jobs in naukri and in all job portals but i
am not getting any call or interview so kindly some one help
me in this regard
based on percentage problems
What can cause bulk solids to stop flowing from a bin?
why screw compressor use for ammonia compression?
send previousyear question paper for ongc gt 2011 chemical
engineering written exam
PLZ ANYONE SEND ME PLACEMENT PAPERS OF I.O.C.L
MY ID---- gaurav.nitw.5609@gmailcom
Where the Induced draft, forced draft & balanced draft
furnace are to be used? Selection of furnaces are based on
Do you have recombinant protein expression experience?
how can i prepare for gate chemical in kolkata
What are advantages using hollow shaft impeller?
In a Furnace arch pressure is more than Hearth
pressure,then how flue gas travels to stack
what is defferance between tubular & automotive plate
design calculations for reactor
For what ration of Lengh/Dia. of tank (Jacketed tank),
maximum heat transfer area is available?