extremely urgent please, why a fuse is used before voltmeter but not with a ammeter connected to a CT(current transformer),thanks in anticipation.
4 8502We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
1655watt meter have 4 terminals what there name??? and what theses 4 terminals indicates ?? and why 2 terminals are short circuited??
1 5571what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
NTPC,
1708why the 4 terminal are named as main, line, common, voltage (M, L, C, v) of a wattmeter?? why not its nameed as A,B,C,D??
6 40507Hi,, Just I want ask, if the power factor decrease what happen in voltage regulation? Thanks..
1 2953Post New Electrical Engineering Questions
slipring induction motor starting time Lrs operating why lrs starting time lrs outer body didn't get shock
What current flows in the transformer primary when its secondary is open?
How line capacitance & line inductance varies with increase in height tower.
Why the earth to phase voltage is high 250 compare to other two phases
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
What is Annunciation?
why the name trunking bus PT
What is the difference between voltages or potential difference? And what are they?
how we calculate the dick for a pole?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
What is reverse power relay?
how to calculate mf when meter and cTPT detail are given
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"