Interested to Buy Any Domain ? << Click Here >> for more details...
After fault clearing in Tr line, whether the Metering core of CT is comes to normal condition from saturation region & its works as a normal condition?
1 3148In our homes we place the 5Amps fuse...now in our house only takes 5Amps for all normal conditions ha???
2 5975if we connect a ohmmeter across shorted capacitor .what will be the reading..will it be zero or infinity
2 7693how many mega ohms insullation of the cable can't be use when testing with megger tester for Low voltage cable 240V use?
3 6060Post New Electrical Engineering Questions
how to erect roof control panel?
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
what is the use of expulsition protective gap in 11Kv line.
Draw the equivalent circuit of crystal oscillator?
What is the difference between Generator Differential Relay and Transformer Differential Relay?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
State thevenin’s theorem?
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
explain all the classes with example
what is gas turbine intercooling ?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
is oil viscosity affect on motor current?
what will happen if OLR CT in all phases are short circuted
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
