Hi, We have have the major losses between BBT ( Bus Bar Trunking) to LT Incomer & LT to HT incomer, how to arrive the losses?
1 3077why in scott connection of transformers, main transformer is tapped at 50% and teaser transformer at 86.6%?
5 31473Sir if i have 2kv ups in which 17ah 8 battries load 600watts how much back up time i get and if i put 6kv ups with the same no of battries same amp can i get more back up time please give reply exactly what is the procedure to calculate back up time for different kv,s
3 5580write encoder 17 pins details? pin a;b+, pin b;w+,..pin s & t. what is the meaning of b+, w+? explain;
1696Post New Electrical Engineering Questions
What is the significance of integral controller and derivative controller in a pid controller?
There is any especial requirement for motor to drive through with VFD?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
why power factor is important?
How many kw will suply from one db
how to select automotive wire by mathematical equation with given current, vlotage and resistance
Explain Continuous and Discrete signals?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
why we change the direction of winding in rotor ?how we make the north and south pole?
