CCNA Interview Questions, Answers for Freshers and Experienced asked in various Company Job Interviews

CCNA Interview Questions

Questions Answers Views Company eMail

Which OSI layer supports the communication component of an application? A.) Data-Link B.) Physical C.) Session D.) Presentation E.) Application F.) Transport

2 7755

Identify the length of an IPX address and it's components? A.) 80 bits, 48 bits network and 32 bits node B.) 32 bits, 16 bits network and 16 bits node C.) None of the above D.) 80 bits, 32 bits network and 48 bits node

1 4210

Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

3 6431

Which OSI layer incorporates the MAC address and the LLC? A.) Data link B.) Network C.) Physcial D.) Transport

4 11025

If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI

1 6905

Identify the 2 characteristics that TCP and UDP share in common? A.) Both use port numbers to identify upper level applications B.) Operate at the Network layer C.) Both are Transport protocols D.) Both are reliable communications

3 11678

Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 4820

Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub

2 4920

Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises

1 4464

Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verifies connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 6554

Identify the 3 characteristics of IPX RIP? A.) Distance vector B.) Does not support multiple paths C.) 60 second updates D.) Default encapsulation is SAP E.) Uses ticks and hop count as a metric

2 5568

Identify the access-list range for an extended IP access-list? A.) 800 - 899 B.) 1 - 99 C.) 1000 - 1099 D.) 100 - 199

1 3912

Identify the X.25 addressing standard? A.) X.121 B.) X.25a C.) ITU-1 D.) Q933a

1 4093

Identify 3 features of IGRP? A.) Composite metric B.) New horizon C.) Flash (triggered) updates D.) 60-second periodic updates E.) Poison reverse

1 3980

Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM

1 4941

Post New CCNA Questions

Un-Answered Questions { CCNA }

Can you explain PPP protocol?

2333

Which defined peer ip address an local subnet belong to crete?

1196

Can you explain voluntary and compulsory tunnels?

1919

Explain the difference between baseband and broadband transmission in ccna?

1142

How do you configure a cisco router for routing ipx?

1297

Which protocol comes under hybrid dynamic type?

1163

What is loop back ip in ipv6?

1221

What is STP and what is the difference between PVST and RSTP

3067

In how many ways you can access the router?

1313

Explain the terms unicast, multicast, broadcast.

1140

When we use standard access-list?

1137

Explain the draw back of ospf protocol?

1090

What is Transport and Tunnel mode?

2351

What is an autonomous system?

1389

When we do default route?

1278

For More Un-Answered { CCNA } Questions Click Here