A default route is analogous to a _________. A. default gateway B. static route C. dynamic route D. one-way route
1 16831Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP
pspl,
2 7200You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp
2 7116As a system administrator, you perform an extended ping at the privileged EXEC prompt. As part of the display, you see "Set DF bit in IP header? [yes] :" What would happen if you answered no at the prompt. A. This lets the router fragment the packet. B. It tells the router not to fragment the packet. C. This lets the router direct the packet to the destination it finds in its routing table. D. It tell the router to send the packet to the next hop router.
1 4080You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.
1 7481Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A. trace B. ping C. telnet D. bootp
1 5657What does the command "IP name-server 255.255.255.255" accomplish? A. It sets the domain name lookup to be a local broadcast. B. This is an illegal command. C. It disables domain name lookup. D. The command is now defunct and has been replaced by "IP server-name ip any"
1 13968As a system administrator, you need to provide your routers with a Domain Name System (DNS) server. How many DNS servers can you specify with one command? A. 6 B. 1 C. 2 D. 4
1 4294How would you configure one host name that points to two IP addresses? A. IP host jacob 1.0.0.5 2.0.0.8 B. IP jacob 1.0.0.5 2.0.0.8 C. IP host jacob 1.0.0.5 D. IP host duplicate "all"
1 6675The following selections show the command prompt and the configuration of the IP network mask. Which two are correct? A. Router#term IP netmask-format { bitcount | decimal | hexadecimal } B. Router(config-if)#IP netmask-format { bitcount | decimal | hexadecimal } C. Router(config-if)#netmask-format { bitcount | decimal | hexadecimal } D. Router#ip netmask-format { bitcount | decimal | hexadecimal }
2 5922When configuring the subnet mask for an IP address, which formats can be used?A. dotted-decimal. B. Hexadecimal C. Bit-count D. Octal E. Binary
1 5344You are given the following address: 153.50.6.27/25. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.255.128, B,153.50.6.0, 153.50.6.127 B. 255.255.255.128, C,153.50.6.0, 153.50.6.127 C. 255.255.255.128, C,153.50.6.127, 153.50.6.0 D. 255.255.255.224, C,153.50.6.0, 153.50.6.127
2 11095You are given the following address: 128.16.32.13/30. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.255.252, B,128.16.32.12, 128.16.32.15 B. 255.255.255.252, C,128.16.32.12, 128.16.32.15 C. 255.255.255.252, B,128.16.32.15, 128.16.32.12 D. 255.255.255.248, B,128.16.32.12, 128.16.32.15
1 7087You are given the following address: 15.16.193.6/21. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.248.0, A, 15.16.192.0, 15.16.199.255 B. 255.255.248.0, B, 15.16.192.0, 15.16.199.255 C. 255.255.248.0, A, 15.16.199.255, 14.15.192.0 D. 255.255.242.0, A, 15.16.192.0, 15.16.199.255
2 8080You have an IP host address of 201.222.5.121 and a subnet mask of 255.255.255.248. What is the broadcast address? A. 201.222.5.127 B. 201.222.5.120 C. 201.222.5.121 D. 201.222.5.122
1 11245
What is the difference between ‘bit rate’ and ‘baud rate’?
Explian what is a node?
Name the protocol which can do load balancing on unequal cost also?
How many ways are there to implement VPN architecture?
What does the meaning of
Define the logical link control?
Which protocol used before part of ccna?
What is poe (power over ethernet)?
Value in which type of access list?
Explain what is the default behavior of access-list?
which points are eliminated by the DBSCAN algorithm?
How do you depict an IP address?
What is DHCP stand for?
What are segments?
What is size of ipv4 mac address?