Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dolphin
inverter is just a
circuit which
converts dc supply
into ac supply. but
ups is a device which
stores electrical
power on normal
conditions and gives
back power to load
when the EB fails to
supply power. an ups
has an inverter circuit.
| Is This Answer Correct ? | 172 Yes | 34 No |
Post New Answer View All Answers
What is the ratio of true power to apparent power in an ac circuit?
What is the control action?
What is negative sequence over voltage element?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
What is limitedly stable system?
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
why on delay timer used for fully automatic star delta starter?
Q: How to calculate Transformer losses , tell us by Formula.
what is the difference between gas group b and gas group c electrical equipment construction wise?
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
can i connect wavetrap in 2 different phase in EHV line?
What is notching in dc machine?
