Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to measure the earth resistance? if so
explain it
- 42 Answers
- 178627 Views
- ABB, BEL, BridgeStone, College School Exams Tests, Dalkia, Dalmia Group, DEC, Electrical, Genpact, HEC, IOCL, JLL, L&T, MSEB, Saraca, Sical, Telecommunications, University Exams, I also Faced
- E-Mail Answers
Answer Posted / dinesh. r
Actually the Earth resistance is measured using "earth
resistance meter". In previous answers some said that using
megger, but megger is used only for high resistance
measurement i.e., in Megaohms but when considereing upon
earth resistance it should not exceed 1ohm so earth
resistance meter is required.
In this meter there will be four terminals(E, P1, P2, P3)
in which E and P1 will be shorted and connected to the grid
or electrode and P2 and P3 are reference electrodes which
will be kept on the earth surface on two different
locations for taking the reference resistances of the earth.
The meter shows the resistance of the earth. But it is
neccessary that it should be below 1ohm.
| Is This Answer Correct ? | 478 Yes | 30 No |
Post New Answer View All Answers
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
How to select the proper VSD to operate high inertial load
how we design a pannel to start 10HP motor with the help of star delta starter?
is there any role of power factor with frequency variation? and how we can manage the frequency variation?
What is a differential amplifier? Also, explain cmrr.
Type of motor stater detail and working detail
Iin ESP why positive is grounded ? why not negative ?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
what is the differences between microprocessor and general purpose computer
Which do you think is the most significant cause of energy loss in a factory?
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
what is mean by D.O. in distribution line poles?
What is the meaning of Insulation H for transformers????
How is the connection of the tap changer on the HV side been made?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
