Interested to Buy Any Domain ? << Click Here >> for more details...
Which commands would assign and enable IPX on an interface ?
A.) enable netware
B.) enable novell-ether
C.) router#(config)ipx routing
D.) You must first enable IPX globally and then
assign the network number to the interface .
E.) enable ipx
F.) router#(config-if)ipx network 4a
- 1 Answers
- 4002 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: C D F
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Can you explain static and dynamic tunnels?
What does aaa stands for?
What is DLCI?
What are the conversion steps of data encapsulation?
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha
Is hub intelligent device?
How many types of ospf configuration?
Which command we give for see routing table?
Which LAN switching method is used in CISCO Catalyst 5000?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
What is overlaod?
What are the different types of passwords used in securing a CISCO router?
What are the different types of cables that are used in routing?
What is subnetting? Why is it used?
Mention what BOOTP is?
