Which two of the following are valid ways to have multiple
encapsulation types on a single interface?
A.) This is not possible
B.) subinterfaces
C.) additional physical interfaces
D.) secondary addresses
- 2 Answers
- 4228 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B D
Cisco routers do not allow multiple encapsulation types on a
single
interface. Therefore, it is necessary to create either a
Secondary
Network, or a Subinterface and assign a new encapsulation type.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Tell me how much hold down time of eigrep protocol?
How many types of ips?
What is subnetting and why it is use?
What is 10base2 ethernet lans?
What is the difference between tracert and traceroute?
What is the difference between the switch, hub, and router?
Explain what is the default behavior of access-list?
What is the mac address?
Explain isakmp ?
Which protocol supenetting is enable by default?
Explain what is formula of hold down time of eigrp protocol?
Which protocols are link states?
What is the difference between static ip addressing and dynamic ip addressing?
What is Route Poisoning?
Which mode called privilege mode?
