Interested to Buy Any Domain ? << Click Here >> for more details...
In step down transformer (415/200V),mistakenly secondary
side is connected to 415V for some hours, what would be
result of this condition?
- 19 Answers
- 28746 Views
- Essar, GAIL, Vizag Steel, I also Faced
- E-Mail Answers
Answer Posted / manoj
as 2ndary side winding is design for 2oo volt so when we
connect 2ndary side to 415 volt,then after some hour the
2ndary winding burnt.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
why dimmerstate always connected in star connection? what will happen if it connected in delta?
What are the basic elements used for modeling mechanical translational system?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
what is dry and wet frequency withstand voltage? why & where it is used??
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
why do we have spikes enough to burn electronic boards, when generators are not grounded
does a DG set has low fault level as compared to that of a transformer.If yes then why.
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
