what is inrush current in transformer?
- 17 Answers
- 38273 Views
- Bhel, Essar, GMR, I also Faced
- E-Mail Answers
Answer Posted / chetan & panks
When we charge the Trafo, flux will get generated there,
but when we make get it isolated some flux will remain
there.
Again while we charge the trafo,remaining flux will oppose
the present flux hence high current will get generated,
which is very dangerous for trafo. The current produced as
in above condition is called Inrush Current, which is
flowing for very minor time (i.e. for 4-5 secs)
| Is This Answer Correct ? | 27 Yes | 31 No |
Post New Answer View All Answers
Why do we perform an open-circuit test and short-circuit test on the transformer?
sir i am apearing for nic exam.i dont know exam pattern.can you please send me some model papers
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
What is the working principle of servo motor? And explain it.
number of I/O devices in siemense plc
What descriptive information does the NEC require to be marked on all conductors?
battery capacity use of made?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
what is magnetizing current test in power transformer
Define cut-off rate?
how we sesign the transformer give some specifion regarding design of transformers
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
what is circuit breaker in transfomer and where it used
