what is plc?
- 27 Answers
- 38471 Views
- HPCL, KRL, Noor Company, Petrochemicals, SS Automation, I also Faced
- E-Mail Answers
Answer Posted / eswaran p
PLC ( Programmable Logic Controller ),it is introduced as
replacement of relay logic circuit, by using PLC
complicated logic can be able to make . it is having
internal memory .
| Is This Answer Correct ? | 73 Yes | 6 No |
Post New Answer View All Answers
How to decrease opening & closing time of on/off valve?
please send data bank of quetions answers on analytical instrumentation.
Which type of pressure can be measured by primary elements?
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
Why MUX JB's are using only Temperature Element in Fundation field bus?
what is the minimum power (P=VI)to produce a spark?
Full form of KKS when use DCS.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Why plc require in analog input 4-20amp & 0-10 volt?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
What is the difference between PLC and DDC?
what effects a surging can produce in the compressor
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
