In step down transformer (415/200V),mistakenly secondary
side is connected to 415V for some hours, what would be
result of this condition?
Answer Posted / maan
Most of electrical equipment are rated at 220v,there
working seriously affected if they recive power at haigher
voltage(415v), also losses in primery side increases and
core loss in secondary side , that may damage winding and
insulation.
| Is This Answer Correct ? | 1 Yes | 9 No |
Post New Answer View All Answers
what is settable hystersis protection? If any body knows plz kindly post the answer..
how to calculation increase power factor for single phase
Why induction motor is widely used in industry
how much GROUND & NEUTRAL VOLT maintain in data center.
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
what is relay what is protection & contact multiplying relays where it is used function in brief
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
why current flow to the opposite direction of flow of electrons???????????
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
what is EIB lighting control system? what is the advantages of this system?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
What happens if we run alternator on under frequency?
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience