What does negative slip of an induction motor signify?
- 10 Answers
- 43627 Views
- Tata Elxsi, I also Faced
- E-Mail Answers
Answer Posted / ankaraju
If the rotor is running more with respect to stator or
meachine synchronous speed called as negative slip.
OR
The injected or developed frequency in rotor is greater
than supply frequency.
significent:Induction motor acts as induction generetor.
| Is This Answer Correct ? | 69 Yes | 11 No |
Post New Answer View All Answers
explain the what is a drive ? 0 4 which type motor r use in the celling fan..... PCB plannet 2 13 If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not?? types of drives Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only. ACC 1 41 how the 3phase induction motor is running in 2phase supply with help of capacitor? 1 33 what is the actual difference betwen constructional details and constructional features? 1 20 how does commutator convert a.c to d.c?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
Why need 3phase machine double earthing?
Define filter?
How the over load setting for HT Motors calculated-provided in Numerical Relay
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
what is value of Jin transformer
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
What is knee point voltage?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
What do you mean by turns ratio of instrument transformer?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
How to calculate the sag of OPGW during stringing???
