Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohammad abutalib
Control valve input signal : 4, 8,12,16,20
Output signal 3,6,9,12,16
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Whatis the reset ofset and control system in instrumentation
What is the difference bitween control net scaner and device net scaner
Name different types of bourdon tubes.
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?
If P will increase then what will happen with PID?
can any send me a forbes marshall dtron 316 manual
What is heating effect?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
How to Calibrate Flammable gas detector in field
Explain types of valves?
this site is owned by an nonsense
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
what is the process for double acting cylinder pneumatic for 32' v/v
