Interested to Buy Any Domain ? << Click Here >> for more details...
How do you connect the capacitors on polyphase circuits?
- 10 Answers
- 52916 Views
- L&T, Transco, I also Faced
- E-Mail Answers
Answer Posted / nagesh.patwari
A delta-connected bank of capacitors is usually applied to voltage classes of 2400 volts or less. In a three-phase system, to supply the same reactive power, the star connection requires a capacitor with a capacitance three times higher than the delta connected capacitor.
Capacitors shall be connected near to the load.Some times Capacitor Banks are connected with the Motor Control Center (MCC) or Power Control Center (PCC) for improving the P F of the system. The voltage rating shall be 10% higher than the system voltage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What about electrical Units. discrive in detail
What is difference between Over Current & Earth Fault protection?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
How to perform a DC resistance test In Alternator and their proceduces?
Please brief what is sinewave
in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Write down the design procedure of commutaj.
What is the tube exial fan?
how does grading rings & spacers in transmission line works? Working Principle?
