Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the multiplication factor in HT incomer
trivector meters
- 9 Answers
- 72907 Views
- Dalkia, Getco, Gujarat Energy Transmission Corporation Limited GETCO, I also Faced
- E-Mail Answers
Answer Posted / sureshmuthusamy
MF = External ct ratio*external pt ratio/metering ct ratio* metering pt ratio(if there)
= 40* (110000/110)/1*1
= 40*1000
=40000kw
= 40w(40000/1000)
so,MF is 40(your daily tariff meter consumption (kwh)*40= consumption /day.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
Electrical Engineering
how to calculate energy of 3-phase motor?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
What facility we get after CT secondary earthing and how?
Differentiate between voltage and current feedback in amplifiers?
What are different types of control systems?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Why is better to have a minimum ceiling voltage of 250% than 160%?
which protection function should measure RMS value of current&DFT value of current?
