What are all the possibilities discharge will be low in the
pumps?
Answer Posted / madhappan kaliyannan
1.NPSH Issue
2.Pump priming not properly
3.Cavitation issues
4.pump direction
5.Required head being higher then the developed head
6.wearing worn out
7.Defend the fluid viscosity.
9.Suction line may be having hole/leakage.
10. Suction line strainer may be got choke
11. Suction line may be volume reduced ( Because of process fluid, like a scale formation )
12. may be more leakages from pump like gland/discharge line/recirculationline
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the b check value of a 4bt engine
What are the symptoms of broke piston ring?
hi sir would u plz kindly send me d previous years IOCL test papers......plz send it to this email id...jomygeorge787@hotmail.com
What are some mechanical laboratory apparatuses?
which type of material is F125?
Differentiate between the uniform flow and non-uniform flow?
Name the indicator diagram.
For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
What is flash steam and flashing phenomena?
What is G U T protection?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
How to report calorific values of fuel?
hi guys ,pls help me......i urgently need previous year question paper for preparation of HPCL (MECHANICAL).pls email me @ mangal_2911@yahoo.co.in
define fans and explain its types?