What is the max demand on your transformer and your company?
Answer Posted / gourav00
always 11kv rating power transformer use in my company..n almost 3 phase transformer use
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
why the neutral point in connnection oscillates?
What are the different methodes for calculating the short circuit Current?
how to calculation increase power factor for single phase
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
What do you mean by dependent and independent voltage sources?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is a synchronizing lamp ?
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
boiler is running in rankine cycle and deisel generator is....?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
What does the term “voltage regulation” means?
What is the earth treantment procedure?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
i have 3500 amp load and select current transformer and perches.how i calculate .please understand