Interested to Buy Any Domain ? << Click Here >> for more details...
How do you connect the capacitors on polyphase circuits?
- 10 Answers
- 53420 Views
- L&T, Transco, I also Faced
- E-Mail Answers
Answer Posted / h r rajyaguru
In three phase load the capacitor bank is connected for improving the power factor (P F). The rating (KVA and V) of the bank can be calculated depending on the existing system voltage and up to which P F we intend to improve. The ideal location of this Capacitor Bank is near to the load. For large size motor / load separate circuit breakers are to be used for switching the said Capacitor Bank. The motor and the bank are to be closed / opened simultaneously. Some times Capacitor Banks are connected with the Motor Control Center (MCC) or Power Control Center (PCC) for improving the P F of the system. The voltage rating shall be 10% higher than the system voltage.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
Why do we avoid electrical conduits in floors at apartments?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
Explain different types of d.c motors? Give their applications
working principles of cf lamp,incandescentlamp and f lamp?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What is a system?
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
plz tell me,ht and lt panel terminals in substations explain beiefly
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
