Interested to Buy Any Domain ? << Click Here >> for more details...
What is the d/f between DOL & star delta starter & automatic
star delta starter?
- 23 Answers
- 165302 Views
- ACC, Dalkia, Engineering, Indeco, NINL, Novotel, RMH Control Systems, Wipro, I also Faced
- E-Mail Answers
Answer Posted / basith
In a DOL starter motor terminals is directly connected to
starter such that initially a very high starting current is
feed to drive the motor.Dol starter is used for small
motors below 5hp because of high starting current may
damage motor winding. Dol starter using for large motor
using star delta connection,first motor run on star
connection mode upto 80% which provide low starting current
and low torque initally and after getting maximum torgue
motor operates on delta mode with high torgue.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
WHAT IS VCB SAFETY
how to calculate insulation level of transformer?
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
What is limitedly stable system?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
how we can calcultae the short circuit level for bus bar
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
what is high and low cut off voltage of BB and DG at SPS????????
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
what kvrah y we need to take the readind of that
what is reverse power relay brief explanation and in b/w where it is connected
What is the application of Dyn1 and Dyn11 vector group of transformer?
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
