Interested to Buy Any Domain ? << Click Here >> for more details...
How can we calculate ngr resistance for a generator and
Transformer ?
What type of transformer requires ngr ?
- 5 Answers
- 43969 Views
- Welspun, I also Faced
- E-Mail Answers
Answer Posted / madivalanagaraja@gmail.co
It is similar to the ground resistor calculation for transformer
The typical example was answered earlier for transformer dt.19-06-2009
Neutral of transformer can be grounded solidly earthed OR with Neutral Grounded with Resistance.
Typical shunt calculations fro 5 MAV 11/6.6 kv transformer neutral are as :_
Transformer rating = 5 MVA
Voltage ratio = 11/6.6 KV
Vector Group = Dyn11 (6.6 KV ground through Resistor)
During Earth fault voltage between Neutral
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
How to run a three phase motor into single phase........
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
describe the Tranformer testing procedure
Advantage of LT panel vs HT panel
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
what is lrs tank water resistance.
control & auxilary circuits used for circuir breakers
why ht motors are star connected?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
What are the material used for resistor?
