how much binding wire is required for one tone steel
- 20 Answers
- 64491 Views
- Gammon, Hinduja, Jindal, I also Faced
- E-Mail Answers
Answer Posted / rajesh ghyar
I think 10 to 13 kg/MT Binding wire is required to bind the reinf. steel. Actually it depends upon the sizes of bars. It consumed less in slab binding whereas it consumes more in columns. But it can be vary in Bridge structure.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have completed building maintenance course in mcvc stream .. can I apply for the post of " sthapstya abhiyantriki sahayyak"?
how to take concrete quantity for precast segment for viaduct project?
What is packing Factor ?
how many type of admixtures for water stored structure?
i have applied 40mm spacer in the concrete for tie beam. is it correct? kindly give me if there any code available
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
if size is 235cmsx15cmx100cms so how many cement bags and how many sand bags are used for concrete mix
HOw much % of premium on DSR-2013 currently
How many kilo-newtons equals 1000 kilogram?
How much area will be covered in 1 litre of Velvet touch paint in normal wall condition
how will calculate 4"thick solid block quantities 1m3 sand cement ratio and breack up detail
how i can calculate the actual nos & size of steel to make 1000sqft. x 3"thick slab
Why should pumping be not used in case of concreting works?
What is Base Shear ?
why top layer of block work shoud be full size if any cut block adjustable than another layer?
