Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using only lead standard solution for Heavy
metals test? what is the purpose of this?
- 4 Answers
- 14152 Views
- Divis Laboratories, I also Faced
- E-Mail Answers
Answer Posted / sandeep
In production mostly we are using GLR and other equipments most of them come up means coating with lead so while in the reaction there is a chances of leaching of lead may takes place that is why we are using mostly lead as a std in HEAVY METALS testing...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
How we performed the force degradation for drug substance, is any specific guideline is available for each parameter(Acidic, basic, oxidation,heat)? what conditions you mentained for above parameters.
why salisylic acid not using now days for disdolution calibration?
how we can identify the impurity is coming below loq at transfering site?
How to establish relative response factor for hplc. Why it is required?
Tell me about analytical method validation in QC
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
What is delay volume?
WHAT IS THE USE OF STARTER ?????????
what is the structure of DOWEX-50
What should be the level/ Percentage of Arsenic in Arsenic free zinc.
Difference between hlaf and rlaf
What is control room temperature and which guide line says?
How to set analytical specification for combination products?
For titration in anhydrous media with perchloric acide, if lack of titrator, Which indicator is been used for replacement. How calculate pH of test solution to choose suitable indicator?
