why we set -10 volt in vibration sensor output,why not +10 volt
- 3 Answers
- 4833 Views
- GE, Honeywell, LLM, I also Faced
- E-Mail Answers
Answer Posted / seenu
What u said all are correct but they are using PNP Transistor
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is dc moter.
Difference between ultra sonic flow meter
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
use of split range ? where it is used ? in which control loop it is used ?
what is 24vdc live and dry supply
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
what is IEC code in cables & how to selecting cables?
What is the purpose of the analyzer in petrochemical plant?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
How is flow measured in square root?
which type of zones used for boiler? & why ?
when a magnet is heated?
How the warning lamp of a charging-system is activated ?
line up procedure for dp type flow transmitter?
