Determine the manipulated variable, controlled variable,
and the measured variable given a description of various
typical industrial processes.
- 6 Answers
- 43940 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / ram
The variables that are manipulated to have control over the process variable is called "manipulated variable"
Eg. Level is maintained by closing or opening the control valve ; here control valve position is "mv"
According to this example , both PV and CV ....is the level of the water in tank
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
Questions on flow meters,few questions on HART protocol,
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
can any send me a forbes marshall dtron 316 manual
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
where cascade loop use ?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
Question on maha cement
What is the Working principle of Dozing valve?
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
