why we multiply 1000 in the determination of kf factor ?
Answer Posted / tejas
Bcz when water and sulphuric acid mix the temperature of solution going high .it's a exothermic reaction
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
acceptance criteria for lod & loq by standard deviation of response and slope??
how many types of balance calibration test?
Tell me about analytical method validation in QC
What is control room temperature and which guide line says?
Home heating oil or furnace oil what is made from? Can (base oil plus diesel/kerosen) = home heating oil?
Loss of linearity in tkn analysis, possible reasons?
What is the purpose of octyl silane columns?
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
we are performed SOR for a particular product the limit is -6 to -10.We face particular bathes it is not meeting the specification.we performed diffrent instrument diffrent analyst we are getting diffrent diffrent results.solvent is dimethyl sulfoxide what could be the reasion
Related substance method equivalency on control sample or spiked sample?
Why are use silicon oil mr?
what is turbidimetric titration?Give 2 examples.
why cone formation during dissolution?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
What is related substance by HPLC impurity limits as per USP?