why 0.1M OR 1M Perchloric acid standardisation done after 24 hours?
- 1 Answers
- 5751 Views
- Cipla, I also Faced
- E-Mail Answers
Answer Posted / b.gangatharan
For non aqueous titrations,the solution should be virtually
anhydrous.Acetic anhydride present in 0.1M HCLO4 solution will absorb all the water from HCLO4 and Glacial acetic acid within 24 hours and renders the solution virtually anhydrous.
Thanks,
B.GANGATHARAN,
CAPLIN POINT.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
We use hicrome 10 cxs column in hplc analysis....pls tell me.. what is the meaning of 10 cxs?
why require the ph, buffer during hplc mobile phase?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
Is it nessesary all multimedia dissolution require descriminatory?
what is mean by covalidation
in gas chromatography what is the difference between gas flow rate and average linear velocity ?
in hplc chromatogram started from left to right and in uv spectrum started from left to right
Qc interview questions
In rs method development when we are going area normalization method to dilute standard method?
in dissolution if one bowl got 70 percent 2nd bowl got 80 percent and 3rd bowl got 90 percent then how proceed?
how many types of balance calibration test?
How to establish relative response factor for hplc. Why it is required?
Why only hydroxy naphthol blue indicator is used for standardisation of 0.05M EDTA solution instead of solochrome Black T or Euriochrome Black T indicator which is used for all sample analysis with 0.05M EDTA solution?
Many times I don't got a caffeine peak in calibration of hplc using guard column ❓
could negative ions be produced by bombardment process in mass spectrometry?
