Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate busbar size & what is the procedure we
make for determine that?
- 35 Answers
- 217797 Views
- Auko Tex, Integra, PowerTech, Shadhin Group, I also Faced
- E-Mail Answers
Answer Posted / suchita
i am very confused about selection of busbar ,please give me proper how to select busbar....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how you configure motorvision relay (L&T make)from DCS
Draw a SLD for main panel for school having connected load of 1200kw and emergency generator 200kw.also show the increase of additional load of chiller 225kw in the lv panel indicating meter postion size of transformer ,cables and capacitor bank.
Why is voltage is required to be within permissible range for an electrical equipment?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
what is the advantages og idmt relay over magnetic relay??
Why star delta starter is preferred with induction motor?
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
why did youi choose this career?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
What are the advantages and disadvantages of short-pitched winding?
