Interested to Buy Any Domain ? << Click Here >> for more details...
which Machine u will prefer to use at place where Flammable
gases are coming out & why ??
- 6 Answers
- 10222 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / perlsdelsur
Firth of all you may have to do a proper harzadous clacification area to determine if the place where you are going to install your motor is DIV 1, 2 or other (done by chemical certificated enginner)then after you must to select the suitable motor for that area operation, motor for harzadous manufacturers can give the information you need but you have to carefully to choice the correct motor because this involve to great riisk to choise a rong motor
Bye
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are protections for dty type transformers
is the value of inductance depends upon the value of thitha in doubly excited machine??
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
what is doubling factor in making current of a breaker?
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
how ct burden,magnetising current,ratio and knee point voltage are related & derived
static chagre
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
Why do not we prefer non conventional sources of energy to conventional sources?
