three phase 180kva diesel generator can take how much load
in amp and what is formula to get this?
Answer Posted / sachin trinagariwar
i think there is no need to go to such formule one thing
and we need to run the generator on 80% load only
so we can consider the rating as follows
180 kva means 180 A
250 kva means 250 A ans so on
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how wecalculate breaking capcity of acb mcb mccb .explain with example
You are of electrical field and you are going for software? Why
How does an oscillator differ from an amplifier?
In siemens PLC, why do we want to move the data ?
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
What is zero of the system?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
State the points to be considered for selecting a particular type wiring.
Write the programming software name for LG, SIEMENS,Messung,AB
what is fault level of power system ?
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
How to determine alternating current frequency?