Interested to Buy Any Domain ? << Click Here >> for more details...
What is the exact meaning for under & over reinforced beams
& when they have to used..
- 11 Answers
- 65136 Views
- Gammon, L&T, MEIL, I also Faced
- E-Mail Answers
Answer Posted / dinusha samarasinghe
reinforced concrete beam section in which the failure stain in concrete is reached earlier than tha yeild stain of steel is reached are called over r/f section
R/F concrete section which the steel reaches yeild stain at loads lower than the loads at which the concret reaches failure strain mean by under R/F section
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is a hatch patterns?
what is Brest Wall?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
How does a traffic light signal work ?
Explain what is the release of lien?
What is the difference between Rock And Murrum. How to claim that excavated material is not a murrum but rock.
how meny typs of renging rod?
Why was the empire state building made of steel?
What is the substitute of Mastic Asphalt?
what is the Purpose of Adding 20% of wet mortar & 1/3rd to Dry Mortar for PCC & Plastering & Rcc .is there any standard method for adding this .?
What are the advantages of cad software’s?
How much form and scaffolding per cubic meter volume of concrete class ''A'', ''B'', and ''C''
What is an ortho mode?
why demand factor less then 1 ?
How to find beam R/F cutting length
