Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the multiplication factor in HT incomer
trivector meters
- 9 Answers
- 73648 Views
- Dalkia, Getco, Gujarat Energy Transmission Corporation Limited GETCO, I also Faced
- E-Mail Answers
Answer Posted / er l r daroch
Line ctr 50/1a
Meter ctr 50/5a
Is it a right combination
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
why would amp draw on neutral wire be as much as amp draw on the hot leg.
Explain the different regions in frequency response?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How to address the servo drive for motor
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
differnce between single acting and double acting solenoid valves
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
which is the best institute for PLC,SCADA,DCS in hyderabad
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
what exactly commisioning work does in electrical site work... LT side?..
what do w do when the output of generator is fluctuating?
how is the incoming cable size calculated for a given current rating of a panel??
What is your acheivements
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
