Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between CT for protection and Ct for
metering?
- 16 Answers
- 128365 Views
- BirlaSoft, I also Faced
- E-Mail Answers
Answer Posted / mahesh
Metering ct needs high accuracy(ie,value of metering ct should be small 0.1,0.2,etc.,) than protection ct ie, metering ct accuracy class will be=0.1,0.2,0.5,1,3 and 5
eg;
The accuracy class of measuring or metering CT is 0.1, means the maximum permissible limit of error is 0.1%, more clearly, if we try to measure 100 A with a 0.1 class CT, the measured value may be either 100.1 or 99.9 A or anything in between these range.
for protection CT the accuracy class is low (ie, value of protection ct should be high 5P,10P,15P)
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
How many double suspension hardware fittings are required on a double circuit transmission tower?
How to select a contactor? How many types of contactors are available
What are the parts in a inverter?
what is the safty of poly phase tranformer?
When we giving the 3 phase supply to ups system how to coming netural?
What would be the size of wire used for 2 Ton of window A.C?
What is the diff. between single compression and double compression gland
66kv under ground cable how to layaing in ground any special case two ckt r runing
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
Difference between megger test equipment and contact resistance meter test instruments?
What is the main use of rotary phase converter ?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
What are the two types of compensation?
Direction of flow of active power and reactive power with logic?
