Interested to Buy Any Domain ? << Click Here >> for more details...
How to Select a Transformer Rating ?
- 3 Answers
- 6751 Views
- Tata Steel Limited, Techno Electric and Engineering, Vedanta, I also Faced
- E-Mail Answers
Answer Posted / biyanka bohra
Transformer's rating is always shown in kva instead of kw because there is no phase difference between current and voltage. it is multiple of primary current and primary voltage for single phase transformer and √3*V*I for three phase transformer
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
How to test the Secure Elite 440 Multi function meter working condition.
How are load losses and no-load losses measured at site in a DG set?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
List some examples of renewable energy?
pls tell me function of closing coil of A.C.B.
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
Name the test signals used in control system
Why use the vcb at high transmission system ? Why can’t use acb?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
