Interested to Buy Any Domain ? << Click Here >> for more details...
HI,how to know that the MEGGER which i am using is working
properly,reply....thankyou
- 2 Answers
- 6175 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / sarkars
If this is an insulation Megger tester,short both terminal momentarily for a short duration and check it's pointer shows zero or not.If it is zero then it is o.k. otherwise not.For checking correctness of Megger reading you have to compare with standard one.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is phase cross over frequency?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
why we r not earthed Control cable of C.T. terminals
do you have some of interview Questions in power and genrator section in general whith answers
what is difference between elr and R eartl realy.
What are approaches to tackle sedimentation problem of reservoir?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
How to reduce -234126219.6403 MVAr generation and by what?
Define resonant peak?
What is oscillator circuit?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
Why do we use copper cable for HT Supply and why not Aluminium?
What happens if i apply 500V to 440V rotary Switch ?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
