Answer Posted / asif imam

When the Ast, design moment , permissible stress are less than that of maximum condition or balanced section is known to be under reinforcment condition.
Where as when the Ast, design moment, permissible stress are more than that of maximum codition or balanced section is knwon to be over reinforcement codition of a section or beam.

Does degree of bend of rebars has any effect on strength of the member? For example- if a beam is designed with 45 degree bent up bar with respect to architechtural needs and is not 45 in practical so will there be any reduction in the strength of member?

2035

---

1.How much batten required for 1 sqm Shuttering. 2.how much pipe & clamps required for staging of 100 sqm shuttering at 5.0 m height.

2245

---

Why are the bolts that hold steel rails together in oval holes?

1103

---

what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.

2314

---

how to check and keep control on the wastage of material at site

2286

---

How can we calculate 8- storied Madrasha Building pile capacity by taking SPT value at site?

1999

---

in block masonry l=10',b=0.5',H=10',Calculate cement ,sand and no.Of blocks?

1928

---

how i convert mm into standard wire guage (SWG)no.

3006

---

Which are the top apps for you civil engineering?

1077

---

What was asked in isro civil interview

1058

---

do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?

1679

---

For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?

1749

---

660 square fit two story house make totally how much cement, sant, brick,aggregate, steel totally how much need

1575

---

What are the ingredients of pre-stressed concrete?

1174

---

pls tell me , what is the water content

2146

---