Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bameshwar
To identify the motor winding is correct or not. Body to coil and coil to coil for identify the motors coils shorted or not. It's values are body to coil-infinity or more than 5megaohms,coil to coil - 0megaohms,and coil to othercoil-we are seeing the insulation between coils
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
How to megger test 11 kV cable and the acceptance IR value
what is meant by skew width in machines?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
How to calculate the phase to phase clearness of HT /// LT bus bar?????
How you calculate the repturing capacity of a HRC fuse
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
How PSV sizing being done
What do you mean by ratio correction factor of instrument transformer?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
Load break swicth maintenance procedure.
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
