Answer Posted / sirohisakshi
If the feed water is too cold then economizer helps in pre heating the water before sending it to feed pump or evaporation zone
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the coefficient expansion of transformer oil?
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces
Which conducts heat faster steel copper or brass?
why does polytropic efficiency of a compressor decrease with increasing flow rate ?
why not a.c supply used to charged the lead acid battery
What type welding electrode is used to weld chrome?
how to calculate stiffners position and size in transformer design
What is the difference between tube and pipe?
Name the four most important components of a Freon refrigeration system.
What is difference between ASME EN & IS related welding procedures(WPS/PQR/WPQ)
3-4 questions on optical fiber : data based.
Inspection for intermediate shaft bearing.
why not soot blowing performed of air preheater, while soot blower is in retract position?
Do you receive good benefits as an engineer job?
